Description
Veto Pro Pac MP1X Leather Backed Small-Sized Tool Pouch
The MP1X is a small-sized tool pouch with both a leather Pocket Stuffer™, that easily slips into pants pockets for a quick retrieval, as well as wire-formed clip for securing to belts and Veto tool bags. Ideal for a minimum amount of electrical or networking tools the MP1X features 3 main pockets sized for linesmen, needlenose or snips and a pair of drivers. A pair of thru-pockets accommodate long shank or handled tools and 6 pen-sized pockets complete the sides of the pouch. The MP1X is topped off with a flush mounted stainless steel tape measure clip.
Specs
PRODUCT SPECIFICATIONS:
- Exterior Height: 10" (25.4 cm)
- Exterior Width: 5" (12.7 cm)
- Exterior Depth: 4.5" (11.4 cm)
- Weight (empty): 0.9lbs/0.41kg
- Internal Volume: N/A
- Max Payload: 5lbs/2.25kg
MAXIMIZED TOOL STORAGE CAPACITY:
- 9 Vertical pockets
- 2 through pockets for long shanked tools
- Back pocket Pocket Stuffer™
- Electrical tape strap
- 2 D-rings
- Wire-formed and nylon plastic belt clip
- Stainless tape clip
- Leather & synthetic fiber construction
OTHER FEATURES:
- Warranty: 5 Years (see Veto warranty terms and conditions)
Includes
- (1) Veto Pro Pac MP1X Leather Backed Small-Sized Tool Pouch
Videos
Resources
Veto Pro Pac Tool Bags Product Care and Maintenance
Keep the Zippers Clean & Lubricated
Over time, dirt and grit will clog the zipper coils preventing them from staying closed. To keep this from happening, clean and lubricate your zippers twice a year (more often if you work on a job site with a high amount of airborne debris). To clean the coils: Scrub them with soapy water; a tooth brush works very well. After scrubbing the coils, blow them out with an air hose to dislodge any other fine grit that didn t dislodge with the brush. To lubricate the coils: Apply a silicone spray, beeswax or a zipper lubricant.
Protect the Zippers From Sharp Objects and/or Excessive Heat
Any sharp object or heat source is capable of permanently damaging the zippers. Once a zipper coil is cut or singed the zipper will not function and in most cases is not repairable. Most of the cut zipper coils we see are the result of sharp tools stored inside the bag with the sharp side facing up. Make sure to keep the sharp edges of your tools facing down in your bag and away from the zipper coils.
Don t Overstuff the Bag
Overstuffing your tool bag will very likely cause significant stress on the zippers that is above and beyond what the bag was built for and will eventually cause the zipper(s) to separate. If you have to work hard to close your zipper(s), your tool bag is most likely overstuffed proceed with caution!
MP1X Product Sheet
Software / App