Zebra MSPRO Mini Split Surge Protector for 120V - 240V

Zebra MSPRO Mini Split Surge Protector for 120V - 240V

A fast and convenient way to protect those expensive Units and Circuit Boards from 'dirty' incoming power and spikes. If incoming voltages remain normal, the MS-PRO simply allows them to pass through the unit unimpeded. However, if the voltage swings (or spikes) too high, the three solid-state devices in the MS-PRO act to clamp or clip off the excess voltage. Typical response time is 28ns - 30 ms. The excess voltage is converted to heat energy and is dissipated, if it is not too much. These protectors can dissipate up to about 8000v for one cycle, or 4000v for two cycles, etc, before being damaged. More voltage will cause the device's poles to short together permanently (often with an audible 'pop') and will cause the circuit breaker to trip - thereby protecting equipment from further damage. The protector's condition is then usually visible inside the clear shrink wrapping as a discoloration and the circuit breaker will continue to trip when power is restored. REPLACE the MS-PRO - do not just disconnect it - it has done its job protecting the unit's components!

Key Features and Benefits

• Works with 120V or 240V systems
• Protects from electrical spikes and surges