Description
Veto Pro Pac MB-MCT Service Tech Tool Bag with Extra-Capacity and Rubber Base
The MB-MCT is a compact tool bag designed for Marine/Boating and other service and installation technicians. This tool organizer is the equivalent of the Veto MC tool bag, with height for long shank tools. It also has tan/marine colors and a TPR rubber base that won't scratch floors or dent door jambs. Built for service technicians, the MB-MC is a compact tool bag designed to stow hand tools, a compact drill and meters.
Key Features & Benefits
- Vertical tool pockets: 44 interior and exterior
- 8" electrical tape strap
- Outside mounted stainless tape measure clip
- 2 tool storage bays
- Holds over 50 tools
- Waterproof Polypropylene, over-molded with non-marking TPR
- Extra wide padded shoulder strap
- YKK locking zippers
- Webbed handle, overmolded rubber grip
- Light gray interior pockets for better visibility
- Marine/tan exterior color
Specs
| Max Payload | 35 lbs |
| Weight (empty) | 5 lbs |
| Height | 13.5 in |
| Depth | 8 in |
| Width | 10 in |
| Waranty | 5 year limited |
Includes
- (1) Veto Pro Pac MB-MCT Service Tech Tool Bag with Extra-Capacity and Rubber Base
Resources
Veto Pro Pac Tool Bags Product Care and Maintenance
Keep the Zippers Clean & Lubricated
Over time, dirt and grit will “clog” the zipper coils preventing them from staying closed. To keep this from happening, clean and lubricate your zippers twice a year (more often if you work on a job site with a high amount of airborne debris). To clean the coils: Scrub them with soapy water; a tooth brush works very well. After scrubbing the coils, blow them out with an air hose to dislodge any other fine grit that didn't dislodge with the brush. To lubricate the coils: Apply a silicone spray, beeswax or a zipper lubricant.
Protect the Zippers From Sharp Objects and/or Excessive Heat
Any sharp object or heat source is capable of permanently damaging the zippers. Once a zipper coil is cut or singed the zipper will not function and in most cases is not repairable. Most of the cut zipper coils we see are the result of sharp tools stored inside the bag with the sharp side facing up. Make sure to keep the sharp edges of your tools facing down in your bag and away from the zipper coils.
Don't Overstuff the Bag
Overstuffing your tool bag will very likely cause significant stress on the zippers that is above and beyond what the bag was built for and will eventually cause the zipper(s) to separate. If you have to work hard to close your zipper(s), your tool bag is most likely overstuffed… proceed with caution!